Summary Of Common Problems in The Cutting Process Of Laser Cutting Machine

_20220222090429

Laser cutting machines are welcomed by all walks of life due to their high cutting speed, narrow slit, high cutting quality, small heat-affected zone, and wide application range. The laser cutting process may be affected by various aspects, so many problems may occur in the cutting process of the laser cutting machine. Let's take a look at it together!

1. Laser cutting can not cut through

Laser power drop or lamp aging

Laser cutting too fast

Contamination of focusing mirror or mirror

The focusing lens is cracked and the focusing effect is deteriorated

Inappropriate focus adjustment

Incorrect laser light path

The voltage is unstable and the laser current is small

The material being cut is highly reflective

Nozzle light outlet blocked

Auxiliary gas pressure too low

Poor cooling effect of cooling system6

2. The starting point and focus of the cutting closed line do not coincide

Looseness between gear and shaft in table

The X-axis and Y-axis guides are not perpendicular

The conveyor belt of X, Y axis is loose

The gap between the slider and the guide rail is too large

The tape is too loose, resulting in backlash

3. The laser head does not generate a light source

Laser power drop or lamp aging

Laser output power is too low

The internal screw of the laser cutting head is loose, causing the optical path to deflect

There is a lot of dust in the laser cavity, which contaminates the diaphragm holder

The cooling system is turned on for a long time without turning on the laser power, resulting in freezing and no light

4. The deviation of the cutting shape of geometric figures is large (circles are cut into ovals, squares are cut into parallelograms)

The parameter settings of the machine tool are not accurate

X, Y axis guides are not vertical

5. The table jumps during the cutting process

Permanent deformation of the drive belt

The transmission gear groove is dirty and the teeth are not properly meshed

Dirt in the pinion grooves in the reduction gears

6. The cutting size is too large

The number of pulses is not set correctly

Radius compensation not set

The factory parameters of the bed are incorrectly set

7. The edge of the cutting surface is seriously melted

Laser output power is too high

Laser cutting speed is too slow

Auxiliary air pressure is too low

Improper nozzle design

8. An alarm occurs when cutting

Software not working, hosting loose

The temperature in the laser cavity is too high because the cooling system is not turned on

The water pressure in the cooling system is too low and the water level is not enough

9. The laser power cannot be turned on

Emergency stop switch closed

Damaged laser power supply


Wyślij zapytanie